Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I've found, it's a timing issue.
When I compile my prog for 8MHz (HS Mode) and run the simulation at 8MHz, it's ok.
My original config, PLLx4 Mode and a Fosc=40 MHz, doesn't work.
Seems the ENC28J60 model from Proteus doesn't want the 10MHz SPI, like the old revison of this ic.
Hi
I've made a simple design with a PIC18F452 and a ENC28J60.
I use CCS C 4.140 and the CCS TCPIP stack.
On simulation with Proteus 8 SP2, I've a problem in the MacInit () function, the check of CLKRDY bit always fail.
I can see spi signals from PIC with oscillo in the reading of ESTAT reg...
Hi all.
After several hours on Google, I couldn't find any informations on a SMD transistor marked "NHR8", in SOT-323 (or 23) package.
Someone's got some specs or type for this transistor ?
Thank You.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
