Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi everyone,
Please help me.
I am making project about SIM908 reading location, after that send to PIC16f887 to show data on LCD. And logitude and latitude I read through GSM pin( TXD and RXD) by "AT+CGPSINF=0".
But when the data shows on LCD, it doesnt ASCII code. Although, Command to PIC send...
You try supply VBAT power mode.
After that you use command "AT+CGPSOUT=0" and this time,you use 2 pin GPS_TXD & GPS_RXD. Now, SIM wili leakage of the signal will and send to continous. You may be use Terminal and Comport uart to receive on PC to testing
Hi, guys.
I am make boar read longgitude and lattitude from SIM908 by PIC 16f887 and show on LCD.
I simulated on Protues it ran ok,
But when test on boar it didn't run.
I don't understand why does it's run
Please help
thanks a lot!!
This program on PIC...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.