Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
thank you so much! i have another question please. whate should be the first step in my design ? should i make sure that my input ans output are matched or should i find the optimum bias for Gm part like you said or what?
Hello everyone ?
i am designing a mixer for optoelectronic data transmission where the input frequency is 26 GHz, LO frequency 0-13 GHz (or below) and output frequency 26-40 GHz.
First question: the switching quad bjts have to operate in saturation so it should be vb about the same as vc or am...
i want to design a mixer for optoelectronic data transmission where the input frequency is 26 GHz, LO frequency 13 GHz (or below) and output frequency 40 GHz. my first question is how can i match the input impedance (50 ohm) using transmission Lines. i know i could use the Inductive degeneration...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
