Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: inductance meter pic
sorry for bothering you, but it would be a real help for me if you can share the schematic and the hex file with me...
my email is juwel_rana82@yahoo.com
Use a led with 4 pin.Short the opposit pins(one's anode with others cathode). Then you will have only 2 pins to connect and by applying voltage with different polarity you will be able to select any one led to turn on.(not both of them with the same time).
I think SUV90N06-05 should do it.As far as I have seen,mosfets need gate pulse of 20v to operate.so you need to boost the 12v.for h bridge,you also need to isolate the ground for upper two mosfets.For safety you should slowly increase the voltage with the frequency.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
