Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
See poorly drawn schematic. I was hoping that if 4V is the minimum, with 5V the MOSFET would open enough to get 1A through. But since I can't provide the 5V from my microcontroller I tried the BJT.
I think you answered it though: without 10V GS voltage it just won't work. In that case is the...
Note that I don't have any experience in electronics so general tips and explanations are also appreciated.
The goal is switch a 5v 1A DC motor with a logic level signal(eventually a microcontroller) powered by a 5v power supply.
To do this I originally got a IRF740 MOSFET. Since then I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
