Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
How do we run the code as in a microcontroller?
When we switch on does it go into a while loop? How do we do that ?
( considering it is a small PC, it might have a boot time and so on, correct ?
The existing code is in Arduion C language not C++
Can we transfer the source code written in C to Beaglebone in some efficient way ?
Is there some way out to reduce the development timeline ?
:thinker:
Obviously all the I/O has to be mapped or some reworks can be expected.
millis()
Description
Returns the number of milliseconds since the Arduino board began running the current program. This number will overflow (go back to zero), after approximately 50 days.
Parameters
None
Returns
Number of milliseconds since the program started (unsigned long)
Example...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
