Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I'm looking for wireless device which can send the log data to my PC. distance between PC and device will be around 3km.
I have search few devices and I found that LoRa will be suitable for my requirement but not sure how much speed i will get at this distance?
I'm planning to use...
When i was creating a footprint i found that footprint create from PCB library expert and Altium IPC Complaint Footprint Wizard does not match. if both follows the same standard then it should give the same result.
After that i have investigate the issue and i found that in Altium designer Toe...
How to port MQTT to any microcontroller?
I download MQTT code from Github but din't understand how to use it for different microcontroller such as NXP,TI,ESP8266...etc
Any body know how to get started with MQTT porting from embedded paho source code?
Hi,
I got easy design from ST TDA2822 but only problem is TDA2822 original chip from ST is not available easily from local supplier. Chinese supplier has cheap TDA2822 but not have idea whether it will work stable or not
Any one has idea about TDA2822 chinese IC performance and stability??
Basically I'm using DRA818 module for walkie talkie application.
In this module squelch level are configurable from 1 - 8 level and 0 - is for continuous scan mode.
If I set 1 - 8 squelch level then during audio reception voice is breaking in between and it is not working properly but the same...
1) I'd implemented the circuit but couldn't get the required output.
MPF103 and audio amplifier section not implemented as in my circuit i'm using LM4871 for amplification.
I'd just monitored the voltage at 560K resistor and collector pin at Q1 but output remain same in both cases when signal...
thanks vfone.
Is there any way to control squelch by software??
Note: I'm using 16 bit micro controller so it doesn't have audio processing capability.
Hi,
This is a basically audio without squelch control.
I want to mute the speaker when there is no signal present. Is there any way to mute this audio??
Please share the schematic
Hi,
I want to write data into internal flash where code is being executed. When i perform write operation on flash at that time i can not read or execute from flash so in this case i have to copy flash related code into RAM.
using __attribute__(("section name")) command I'd successfully...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.