Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello Ravi,
From data sheet :
Debugging and Programming Interface
-- MSP-FET430UIF (USB)
-- MSP-FET430PIF (Parallel Port)
Search on google will give you many DIY programming tools.
I don't have any experience with TI so cant give you any advice here.
Good luck!
Every display with reasonable resolution can display these signs, its just part of the software in the calculator and not specific for this display.
And yes, i've read the datasheet of the calculator. With natural display they mean the representation of what is shown on the display (the signs)...
Hello farzaneh_2561,
What do you mean with driver ? What do you want to do with it ? And why do you want to use an FPGA/CLPD for this.
Since the W5300 has hardwired TCP/IP, MAC this chip basically is the driver.
If you repeatedly want to send the same set of data is should be doable to...
Hello Ilia,
As i read your question i notice you have no experience with micro controllers or programming.
Before you start with the STM32L152C DISCOVERY Board you should start with leaning the basics :
- Microcontrollers :https://en.wikipedia.org/wiki/Microcontroller
- Programming ...
Hello Eshal,
What do you mean by natural display ?
As far as i'm aware the Casio 991ES calculator has just a normal dot matrix display.
Those calculator displays are in most cases specially made for/by the manufacturer.
You could open one, en check the display yourself.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.