Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Microstrip line in HFSS
Hi miki1234. You must increase the computational domain (the airbox in your case) using, for example, the next values:
position: -35,-35,-20
XSize: 70
YSize: 70
ZSize: 40
(the values were probed in the second example attached in your file)
changing those values...
emi filter choose
Hi Saumya_85. There are several EMI filters topologies. I recommend you the book:
"EMI Filter design"
Richard Lee Ozenbaugh
ISBN: 0-8247-8924-5.
The best fit can be obtained using an LC filter, but you need to get the toroid which best performance range is in the mitigation...
microstripes 7.0
Hi. The newer version is MICROSTRIPES 2009 delivered by Computer Simulation
Technologies (CST). Here is a microstrip patch antenna tutorial (Microstripes 2009). I hope it will be usefull for you.
micro strip antennas filter design
Hi, as well known we can simulate microstrip filters and micristrip antennas with several EM simulators. If I simulate a DGS low-pass filter, which parameter show me that the filter does not radiate as a microstrip antenna? I want to be sure that the design...
Re: Defected Ground Structures and Defected microstrip struc
Hi, what are you looking for? Do you need help in the DGS filter design? what kind of filter do you need? If you post your needs may be we could help you.
regards
Re: ebg under cst pls?
Hi abdoeng, I downloaded the file you post, but unfortunatly I have an older CST Microwave Studio version (5), so I can´t open your file with my CST program. Are you implementing the EBG structure on CST Microwave studio? I´m studying the paper published in the microwave...
Hi. If you attach you desing may be I could help you. I can tell you that you have to define most of the parameters (dielectric loss tangential, lande G factor, etc) in order to obtain the better response. Greetings
Re: ebg under cst pls?
Hi. I´m working with EBG´s with CST, HFFS and EZ-FDTD sotfware, In my opinion HFSS may give you a better aproach instead of CST. I think that CST is more easy to use compared to the HFSS but the simulation results are better. If you describe your problem I´d like to help...
fractal antenna +ebg
hi heviraf. I´ve been working with EBG´s to mitigate simultaneous switching noise and recently I´m studying DGS to do the same. I´ve designed a mushroom-like EBG in a double layer PCB. I´d like to know more about your project to try to help you. Greetings
matched termination
Hi, I´d like to know more about your problem. I suppose that you want to attach a coax cable to a rectangular wave guide, so my question is...Does your wave guide have a 50 Ohms termination in the side where the coax cable must be attached?. Does your coax cable will be the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
