Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: who export dxf circuitcam
Hi there, although your post is quite some time ago, but i hope my answer helps others.
I'm also using HFSS version 8, and i export my design in the form of .SAT (version 5), then i import into CST. then export in GERBER file using CST.
** REMEMBER: delete...
hi everyone,
my question is how to improve the impedance of circular patch if i'm using probe feeding.
i've come across with the idea of feeding position, is there any conventional equation?? or i need to try all of them?
thank you very much in advance!!
any comment will be appreciated.
I have tried a few substrate with different relative permittivity, and now i have one question about it.
Does relative permittivity affect our design? (other than dimension)
is higher relative permittivity can give us better performance?
and lastly, is there any standard/rules on which relative...
hi everyone!
I'm now going to start a project which requires knowledge of patch coupler.
can someone provide me some related links or information?
thank you very much!!
hi everyone,
I tried to export my S-param as well, but it pops up a message saying that i have to renormalized to 50 ohm??
izzit because of i did de-embed??
Re: Microstrip Inductor
hi there,
i was wondering, how could you measure the inductance of microstrip line?
because i am doing the same thing a you, but i'm in reverse, i need to convert microstrip line back to inductor or capacitor (component)
hi everyone, i have quite similar question as kellyza mentioned.
However, I'm my question is: how to convert a matching circuit (microstrip-open circuited stub) into lump element.
my purpose in doing this is because of saving space.
thx in advance for replying.
i'm designing a Power amplifier using AWR.
and i dont know which way of laying out my circuit is the correct way.
can someone enlighten me pls?
i will attach my matching circuit as well.
thx in advance!!
hi there,
i'm designing a power amp as well.
AWR is my simulation software.
may i ask how do u plot them out?
could u pls share those steps?
thanks in advace!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
