Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You can do it in hfss circuit using the dynamic link. Simulate your antenna and import the results into the circuit, apply whatever voltage you want, run the simulation again, you both circuit and hfss results will be dynamically interlinked.
Hey folks,
I am simulating a simple 50 ohms transmission line in HFSS, however, the results are nowhere near expected results. I was expecting mag(z(1,1) to be roughly around 50 ohms or in between (40-70) but surprisingly I am getting worse than that. When simulate the same design in ADS it...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.