Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi!
I'm designing a board with both digital and analog supplies. for the digital supplies i need an isolated and regulalted DC/DC converter with 12v in and 3.3V out. my smile will grunt to those of you who would answering correctly:)
Thanks!
J.
Hi
I'm connecting cyclone 2 lvds transmiter to 3 meters long ethernet cables(RJ45 connector), besides impedance matiching, sould i consider any other issue for this conections?
Thanks
Joana
channel array to gain
Hi all !
I have 128 channels, each channel output's a signals in the range of 10mV to 0.1V
and from 0Hz to 1kHz, and I have to increase all of them by X100.
My question is refer to all of you experienced folks:
is there a device that acts as array of amps for this...
Hi all
I dont understand what is the difference between 'Single-Ended' ,'Differential' and 'Pseudo-Differential' amplifiers..
Where can I find some materials/ articles about it? typical usage and schematics?
thanks for the help:)
Johana
I'm designing a board and I have multiple analog channels witch I need to sample with the same A2D.
So far, The only solution I thought of, is to use MUX and allocate a time slot to each channel and then sample it. before i'll start with these way, i want to ask if there is another way to deal...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.