Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
I have designed a rectangular patch antenna using HFSS, and I want to vary the patch dimensions (Wp & Lp) in order to analyze its influences on the antenna performance.
So, my question is how to sweep Wp and Lp to plot the efficiency Vs Wp and Lp ??.
Thanks
why ADS only ----> bcz i wanna simulate a rectifier circuit , and this filter is for matching the impedance of rectifier (complexe impedance) to antenna's impedance (50 Ohm). So, i need a tool included in ADS which allows me to enter any impedance value.
Note : i used ADS design filter but i...
Hello, I want to synthesize a filter of order 2 to achieve the adaptation between two known Zin and Zl. Can anyone show me an automatic filter synthesis tool included in ADS ???
Thanks
Hello, i have a rectifier circuit on ADS and i want to simulate """Efficiency vs Frequency"" . any one can show me how to do that.
NB: i tried to sweep frequency on HB but i had no result.
Hello, i have i rectifier with serie diode as shown in figure, i calculate Zin=2.5+j*75.48 , when i match it on 50 Ohm i got this result : S11= -0.7 and real Zin not near 50 Ohm ..... any one can tell me where is the problem ?
Hello, can anyone help me.
I have a rectifier as shown in attachment, and i want to make a matching circuit using smith chart utility . when i open it i got this problem. so please help me to solve it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.