Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Yes Sir, I have done DC, AC and Transient analyses for various circuits. But for the first time I am using HSPICE RF for my RF circuit design.I am successfully able to plot all the S-parameter and Noise Figure for my designed circuit. But getting no results for 1dB and IIP3 evaluation. Even I am...
the log file is like :
************************************************************************
HSPICE RF -- A-2008.03 (Feb 26 2008)
Copyright (C) 2008 Synopsys,Inc. All rights reserved.
This software and the associated documentation are confidential and
proprietary to Synopsys, Inc. Your use...
I have used your's given command :
.param freq1=1.90e9 freq2=1.91e9
.HB tones=freq1,freq2 nharms=6,6 sweep Pin:W DEC 10 1e-6 1e-3
.probe HB P(Rload) P(Rload)[1,0] P(Rload)[2,0] P(Rload)[2,-1]
But, It still give "NO data in design" .
Thank You,
Sir, The actual netlist created by Synopsys EDA tool after simulating the schematic is this :
.param prf='-40db' frf=100meg
.option PARHIER = LOCAL
.option ARTIST=2 PSF=2
.temp 25
.lib '/root/synopsys/SAED_PDK90nm/hspice/SAED90nm.lib' TT_12
*Custom Designer (TM) Version...
Sir, after implementing the circuit in Synopsis Custom Designer, I am following these steps:
Custom Designer =>Tool=>SAE=>Setup=>Analysis=>RF=> hb=> ( Fundamental tone=2, Tone1=100M(say), Tone1=200M(say), No. of Harmonics1=10, No. of Harmonics1=10, Sweep variable=pin( which is at my input)...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
