Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear all, I express my question again:
The point is that I've found that those simulators doesn't always represent what happens in real world. Particularly, if you use a dense mesh the result would be poorer than for initial meshes.
However, according to simulator working principle, when an...
Rugbyfun,
I couldn't say the modellization is wrong. In fact, for adaptive pass number 2 or 3 the solver results are very similar to real ones. If you let it solve new passes, then you can see the results start to go in a wrong way.
I have seen that with a 2.5D model in ensemble, the |q|...
hfss convergence mesh
In these softs, when an adaptive solution is chosen, the mesh between consecutive solutions is automatically adapted by the program so that the current solution is theoretically more accurate than the previous one.
However, after measuring some devices, I have found that...
Re: Powerline Communication
There are several chips you can use and that are offered. I think you should consider the requirements. Powerlines are too noisy with high levels of attenuation, specially for long distances.
Be carefull with levels of performance that appear in datasheets...
Re: use of ansoft designer
I haven't used v2. However, this may help:
In v1 the solver that is used affects the solving time and memory.
The solver selection settings are the same in both cases? In v1 you can configure this.
making sma cable
Hi Flatulent,
Thank you for your response.
I have very long cable lengths to cut it with enough precision.
Also, I am not allowed to insert discret components.
I am trying to use, preferently, a method of tuning the cable while one of the connectors has been soldered. After...
phase matched cables
Hi,
I need to make semirigid coaxial assemblies matched to +/- 0.5 degrees (at about 1GHz). :(
Does anybody know where I can find a tutorial/book?
Does anybody can send a tip?
Thanks! :D
Re: question regarding ansoft maxwell 2D repetitive simulati
I don't know if our software versions are the same. If so, you have to do the following:
1) create "optimetrics" project using the project manager. You can use this program to optimize structures or to run parametric simulations...
I am developing a method to estimate semirigid coaxial cable parameters. This method needs a copper disc in order to short circuit the outter conductor and the center conductor. This disc has a hole in its center for the cable inner conductor to penetrate it (the disc is like a copper washer)...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
