Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi guys all right, about the lamp would be a maximum 60w incandescent lamp at 110vac voltage with 3 levels of brightness being the last touch to turn off the lamp. I know that there is a dedicated TT6061 CI that does this function but I would take more than a week to receive it, I wanted to...
I would like to assemble a circuit that drives a lamp of up to 60w controlled by touch in 3 levels of brightness and in the 4th touch the lamp turns off, if possible, using accessible components.
I have a 45x45 mm square plate with 8 infrared leds all connected in series. I need these infrared leds to flash at a frequency set by me. You would need to mount an oscillator for this purpose.
LED panel model -> F3 LIGHT with a total of 16 columns and 8 rows of LEDs. 5v power and controlled by an Atmega 88 and being excited by 2 TLC5940. I have 4 equal panels and some are with the TLC5940 (some are burned) and other panels are with the Atmega 8 burned. My question is whether I can...
I suspected the integrated TNY278 that I tried to replace with a new one but after replacing the component the defect persists.
The voltage on the green wire at the source output does not exist.
The voltage over the electrolytic capacitor of primary after the rectifying bridge is around 175V...
I've already seen comments that in the Proteus simulation program works but in practice it's not quite like that. Is it then that no PIC and AVR simulation program works, in practice as in the program?
To start I'm a beginner in programming, I would like to set up analog and digital circuits using PIC and AVR that use 7 segment displays, lcd display, to teach me also in fusebits.
About programming, what do experts recommend?
/ the ideal would be a programming that is not very difficult to...
I need datasheet pwm 1910-10 smd
I have a microwave from Eletrolux that was turned on at 220v. I suspect that the integrated 1910-10 is damaged. Now I need to locate the datasheet for this component.
I have a 60w Hikari 110v soldering iron (welder) where the copper ferrule broke inside the welder, how can I remove this copper ferrule?
The copper tip broke inside the body of the Hikari 60W welding iron. The electrical resistance is ok .
The only thing I need to do is remove this copper tip.
I started by checking the monitors I have in my workshop and found an Intelbras monitor that also says it's a 716SW AOC. When opening this intelbras monitor I found the inverter transformer of the same size and the same pinning as the AOC F19L monitor. I removed it and put it on the F19L monitor...
When I opened the monitor I noticed that someone (another technician) has already moved the monitor, in addition to making a mess disconnected the cables that connect in the bulbs, also removed the transformer from the inverter.
Now, how to solve this problem? I do not know how to get this...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
