Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The IR2104STRPBF is a Half Bridge Controller for the current driver. If you check the data sheet, you will see how it works.
The normal way to obtain a delay in order to avoid a short current is using a delay cell (nand, and, or, etc) to get a deadtime.
Hope will help!
Jesus
Re: [moved] Help with wifi booster
Hey!! I see with more attention the product and I see that it is not a PLC. It is a wifi repeater.
Sorry!!
Best regards
Re: [moved] Help with wifi booster
Hello! What you are looking for its named Power Line Communication. It is a real challenge, because you need to establish a communication through the power line with the modem and then, you need to have the proper hardware to send the signal, as any...
Suposse that you have two systems with A1(x)= G*(x+1) and A2(x) = G*(x+1)^2 representing its respectives behaviour. Now, introduce an input x= Cos(wt). Then, A1(x) = G*B*Cos(wt) + G and A2(x)= G*(B^2*Cos^2(wt)+2*B*Cos(wt)+1) =(after some algebra).. = G*(3/2+ 2*B*Cos(wt)+ B^2*Cos(2wt)/2). From...
You can check Leeson formula for phase noise or you can read about the linear time variant theory of phase noise published by Thomas Lee and Ali Hajimiri. Otherwise, you can better the phase noise increasing the Q of your resonant LC circuit, increasing the power dissipation or adjusting the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
