Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In an MPU with a supply voltage range of 3.3 to 5 volts I want to use the output of a switch mode chip that has a ripple of about a volt within that range to provide the supply voltage. Datasheets are silent on the allowable ripple, both magnitude & frequency. Texas Instruments says that's not a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.