Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I couldn't describe my question correctly. I cannot do abutment for transistors manually in the Layout L. I haven't any problem by the Layout XL.
In the Layout L when I remove a contact of drain/source manually just its metal will be removed and its diffusion will remain. Whether this can be...
Hello,
I'm working with TSMC PDK and I faced a problem in abutment setting in the Layout L Editing.
However, when I use the Layout XL, The elimination of the contacts of the Drain/Source of two transistors which are connected to each other and i haven't any contact from them will do...
Yes, it works.
But as I said just it cannot recognize the poly pin. I totally agree with you which using metal is more convenient than poly, but in some cases in a short distance and limited space it is better to use poly for connection. Because you need to two poly-Metal contact on the gates...
Hello,
Yes I did that. The error just related to pin of poly (missing port A; which is defined as poly pin). I think in TSMC PDK we just can use of metal to pin definition...
Hello,
I have a question towards the pin definition on a poly net. As a simple example when I have a layout of the inverter and define a pin for its gate which has been connected by poly, it will not recognize by the LVS check as the port. However, it is obvious as the pin in the Navigator...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.