Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hello,
yeah it is just to implement the idea.
And another problem is that at the microcontroller the output is of 8 bit and RFID Tx and Rx are of 4 bit so what should I do to make 8 bit controller o/p into 4 bit.
---------- Post added at 19:46 ---------- Previous post was at 19:44 ----------
I...
I want the circuit of interfacing of ADC0804 , AT89s52 and 16X2 LCD.
program code is also my problem. but i will not tell any one to do it for me.!
dont worry.
And thank you for 1st reply of my 1st post..
I am making a weight measuring system that measure weight an display it using RFID.
block diagram is attached below.
I have completed receiver part.
I am facing the problem of amplifying the load cell output and interfacing it to LCD through ADC0804 and microcontroller AT89s52.
I have lake...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
