Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i write a program. the add of D0 to D7 and A0 to A7. is it jst can use to have 1 memory onli?
the data add. can be get more or not?
such as..
move.b #2,d0
move.b d1,d2
with this, im using 3 data address already.
what can i do or still hv any thing im still not undersand?
allow me to ask again. coz im really don't know how to write a program to my trainning kit.
my lecture show me the 7 segment program, such as:-
* 7 segment interface-one digit counter
begin org $080c00
move.b #$80,$10000d * set PACR to mode 1x
move.b...
thanks for reply.
i have read that data sheet already, problem is, i don't know how to use the code.
such as how to control the motor run by using switch.
HELP PLS!
can any body help me?
i need to know how to write the mnemonic code?
i cannot understand at all, but i need to do my assingment.
project :
control the DC motor RUN by the button switch (ofrward and reverse).
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.