Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi everyone
I recently wanted to try to simulate the Radar cross section of a ship using HFSS.
But I have a problem
How to emit electromagnetic waves to ships from phi = 0~180 degrees?
Am I set the plane wave excitation? (As shown below)
Note: There is no electromagnetic wave under the ship...
Hello everyone:
I want to calculate the radar cross section of this ship with ANSYS HFSS,but when I set the plane wave excitation, I can only set the incident wave in a fixed direction.
For example, I set the E0 vector to (0,0,1) ,k vector is (-1,0,0), but I want to directly set the incident...
Excuse me,I want to ask you another question. If I want to reduce the precision of the mesh in ANSYS HFSS.How do I set the correct settings?
I get from HFSS-> Mesh Operation-> Assign-> and I get four options are On Selection, Inside Selection, Surface Approximation, Model Resolution .
How to do...
Thank you answer my question!! You help me a lot!!!!!
I never use HFSS-IE, is it can solve the FEM solver is related to memory requirement or maybe I need set my cube shrink a little?
Hello everyone:
I recently started to study ANSYS HFSS because of my research needs.
At first, my professor asked me to draw a 50-meter-long boat and set a frequency of 5MHz to measure the radar cross section of the ship. There was no problem in this part.
And then my professor asked me to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
