Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Sorry, it is connected, I was a bit slack with the schematic. You're right, when I adjust the pots so the input resistor is too low they do begin to oscillate. Am I better off having a small gain for the first stage then increasing the gain in subsequent stages? Or will the noise introduction be...
Hi all, I am working on designing an IF amplifier using opamps and just need some guidance as to whether I am on the right track as this is not one of my areas of expertise.
The input signal is from a frequency mixer, fed by frequencies of approximately 2.45GHz. I am only interested in...
That is great news, thanks for your help.
Can I assume the same will apply with a circulator, i.e: if my received signal (approx -85 dBm) is at a slightly different frequency to the transmitted signal, will the receiver still receive the different freqeuncy even though approximately 10dBm will...
Hi there. I want to use a frequency mixer with a LO power of 6 dBm and an expected RF input of -60 dBm. If the specified LO-RF isolation is 35 dB, what would be the effect of this insufficient isolation?
Would there still be an IF output of |Frf-Flo| at a lower power or would this not be seen...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.