Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Good day!
I made a basic Arduino program that prints "1" and "0" at a delay of 500ms per string using the following Arduino UNO code:
void setup() {
// put your setup code here, to run once:
Serial.begin (9600);
}
void loop() {
// put your main code here, to run repeatedly...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
