Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am trying to make an SMPS.
While powering the SMPS ,it is getting tripped.
It works same even we power using 230 VAC without driving signals.(gate trigger)
After MCB get tripped,if i power the PWM driver board(12V), it works fine and gets some voltage in the output and gradually disappears as...
Thanks for your quick reply........
But i need "SOURCE CODE" of this project in order to make a USB programmer.
It will be more helpful if you can provide the C file for 8051 controller.
with thanks
jaiju.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
