Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I would suggest that you implement PHOG and classify it using SVM or other classifiers. Principle Component Analysis can give you a little less efficiency.
- - - Updated - - -
Yasmina, for face recognition you can simply use PCA algorithm. Anyway, if you are keen on doing the other way round...
Try using a lower rated power supply. If the rating of Atmega32A is lower than that of the latter, there's indeed a possibility that higher current supply to the controller could cease the functioning and the micro-controller itself could turn-off to protect the circuit.
For example: Our...
The answer to your question is YES as well as NO!!!!
Yes because serial pin is basically a port pin with an extra function.
And NO, because, when you perform serial communication there's a requirement of Some frequency(BAUD RATE) which any other normal pins do not have d ability except for P3.0...
Re: PLZ!!!!!>>>>>HELP REQUIRED>>>>>
Hey I have the same doubt and I am stuck in the same situation like you were as mentioned in the thread.
Could you be of any help to me?
I am in third year and doing the same for my mini-project.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.