Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Yes, the outcome is available at node 2. It is the output photon power of the laser. We need the L-I curves of the laser which is the same as DC analysis in Pspice and should like this.
Also other two results should like this which is correspondence to AC analysis and transient analysis .
I tried to build a simple QCL(quantum cascade laser) model based on 2-level rate equations in Pspice. The codes are as follows, but I can't get the right probe output. May someone give me some advice, please. your help will be very appreciated !
The codes:
QCL MODEL
Id 0 1 1A AC 0.5A
Itr 0 1...
hi,
I do a folded slot antenna design in hfss , following this paper. But I am not sure about the principle underlie the design .Welcome someone give some advise about my sample project !:lol:
Hi Guys,
I wanna to make a wireless network adapter myself , Can someone give me some detail advise ! I have a notebook , and I am not satisified with the network interface equipped . So, I want to do my self ,also with a DIY Antenna . using USB ;-)
Hi ,Guys !
I just encounter a problem . After i closed a project i had saved ,then I want to open it .
the screen display message like this:
" Project E:/Ansoft/Projects/Dipole.hfss is locked.If the project is currently in use ,recovering will cause data corruption or software failure.
Do you...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.