Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I'm simulating a simple microstrip structure (picture). I tried different mesh-settings to have a better field resolution (looking at the e-field which seem to be kind of square-cut) but nothing changes. S-Parameter are also almost constant for even finer mesh. Is it a purely grafical issue...
Hey there,
Just started to do EM simulation with ADS Momentum. Simulation results of a simple microstrip line (lambda/4 @ ~90GHz) looks like this:
I defined 2 Ports using 4 Pins for excitation. You can see the standing waves on the ground plane at all lambda/4.
How can I solve this...
Hey there!
I want to model an ideal diode in ADS using a SDD component! Zero current below threshold voltage Vth and zero resistence above. Can't be too difficult but I simply cannot figure it out (which is rediculous). Anyway, this is what I tried for the equ: " I[1,0] =if (_v1<0.7) then (0)...
TRL Calibration (non-zero thru)
Hey,
I've already designed Thru, Line and Reflect Standards. Unfortunately I had to add some extra line in all 3 standards because of my general setup. Consequently, the reference plane is shifted. This means, that the Errorboxes (calculated by the TRL Matlab...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.