Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi!
sorry for so late,but with a little child I haven't time to power on the PC.
Be sure that your clone is running because if not running you can not configure mplab.
for installing the drivers of icd2 clone in windows xp for mplab ,after the installation of mplab,go to c on program and...
Hi!
I use another firmware,not the firmware with the project.
You must install the driver like the original icd2.
Intall MPLAB IDE from microchip,after write to me at this address:
iw3sgg@gmail.com
Bye!!!
ICD2 Clone 4550 USB
Hi at all!
I build a icd2 clone 4550 at http://icd2clone.com/wiki/Main_Page Pics rev B (the first),but I don't know how I can install it with mplab.
When I connect the icd2 at the usb windows xp don't show the installing new hardware wizard.
Mplab is the leatest version 8.4...
H!,
It isn't the first pic that I program,I had programmed the 4550 but I can not try the icd2 because
I'havent the usb connector.
Thanks fot link of software,I try it tomorrow.
bye I must go at work now,see you later.
Thanks WP100 for your repply,I'm sorry for delay to response you but with little kid
I haven't much time to spend for hobby!!!
What programmer you use??What software you use to program PIC???
I'm working in a factory that made PCB......see www.tecnomasterspa.com
For me is simply to made PCD...
Hi at all,
I'm Noris from Italy and I'm building a ICD2 clone 4550 revB at http://icd2clone.com/wiki/Main_Page.
Some answer:
1)What is the right version of mplab ide that runs corectly with this ICD2??
2)For programming the 4550 I must set MCLR Disabled,RE3 Enabled
For programming the PIC I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
