Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you for your support!
Yes I know what, my battery has protected PCB that has cut off voltage at 3.0 V of Battery
and the same protected PCB has max pulse current of 1.5A and short circuit detection to save the battery
Thank you for your support!
I understand that I can give more power that have so I trying to give what I can:
3.7V * 1000 mA = 3.7W
And on output I can have not more than 3.7W, at least 0.6-0.7A * 5V = 3 - 3.5W
I have done it and its charge the phone but with some problems with form of 5V at...
Hello!
Im developing mobile phone charger for myself and I have done it but works not correctly
https://obrazki.elektroda.pl/9353432000_1409391370.jpg
I have rechargable 1000 mA/h 3.7V Li-Pol Battery with 1.5A max pulse current and 3.0V cut-off voltage
And I have to supply 5V+-0.1V load with...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.