Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi every one i am using optocoupler pic817 for my pwm based h-bridge driving circuit. is it a right choice for this circuit...or should i need to replace it with some other package?
one more thing that i want to clear is,currently i am using emiiters output which is being further fed into...
yes barry i have oscilloscope. actually my requirement is to made a variable frequency drive varying frequency from 5hz to 50Hz in order to drive a ac induction motor at variable frequency and speed.
what does this mean? that my mosfets are in backward?
actually i am also thinking about my...
oppss my fault
yes i am using ir2110 in my circuit but in the schematic i have given is ir2112 is being used.
actually you know this fact that for proper switching of mosfet gate voltage Vg should be 10-15V more than source voltage.right? but in my case both the voltage i.e Vg and Vs are...
hi every body
i am implementing the following circuit on bread board.but unfortunately i am encountering few problems
my first problem is V(gs) is zero due to which no current is passing through the mosfet
what is the possible reason behind it?
i am applying 50hz pwm signal at input of gate...
thanks for your reply actually i am trying to generate 50Hz sinewave by applying a pwm signal at gate driver ic.having maximum pwm freq 6.4KHz .can u plz suggest me tha appropriate diode for proper switching ?
- - - Updated - - -
i appreciate your concern for my question.actually i am...
thanks alot for ur reply
actually my aim is to drive an ac motor while giving a pwm signal at gate driver IC . but before that i was testing it using a simple dc motor as load
u highlighted a very important point regarding load resistance
can u plz elaborate it a bit more
regards
- - -...
hi everyone
i am trying to drive a H-bridge using high rating mosfet irf840 and gate driver ic ir2112.but this circuit is not working as i am using a dc motor as load. while this circuit works efficiently for MOSFET irf3205S. i am untable troubleshoot. can anyone ple tell me the problem due to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.