Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Firstly, if I am not wrong then according to my knowledge we have to maintain a specific pitch distance or multiples of it between all I/O pins while doing a physical layout designing. This is to help an auto-routing tool so that it will not miss any pins while auto-routing saving us a manual...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
