Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
I also received today an answer from Onsemi company which states:
"This is not a problem at all. The internal triac can handle non-repetitive pulses of up to 1A. If you are driving just 10mA then it will not affect the device in any negative way."
But considering the power dissipation...
Hello,
Thank you for your fast response. Indeed, I did not considered the power dissipation calculation on the device.
According to datasheet:
- Peak Non−Repetitive Surge Current (Single Cycle 60 Hz Sine Wave) = 1A
- Total Power Dissipation at 25°C Ambient = 300 mW
- Total Power Dissipation...
Hello,
I know that MOC3052M is designed as triac driver, but I have to drive a small load of 10mA and I tried to drive it directlly from MOC, without using the second triac, as sugested in datasheet.
It is working without any problem. I limit the current trough triac as a double safety measure...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
