Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear Goldsmith
cant find a PQ4040 in the market here,
I have EE42 and EE55 available can they be used instead ?
specs for the supply are, freq 100khz, input 220VAC, output 56V 20A
will try a SEPIC configuration first, if I fail to get good results then will try a push pull mode.
best...
I thought you were going to post a power table for example what size Core should be used for required Watts
for example
I use a EE25 Core for 15Volts 1.8 Amp, but I am not sure if more power can be attained from this core size
I want to make a 1100 watt converter from 220 VAC to 56 Volt DC...
to what voltage can a Lead Acid battery be discharged without damaging it ?
A fully charged battery has 14.2 Volts
how can we achieve that with 13.8 volts of charging voltage ?
if you can be more specific about what you actually require to do maybe then we can help you,
uptil now the whole thing is confusing
how can you get 50 Volt AC out of an Audio amplifier I fail to understand
AC vibrators are different in structure from DC vibrators
they need a change in flow...
Dear Goldsmithl
can you suggest a ferrite transformer design for the following specs.
Buck converter
Input 220 VAC ( 312 VDC at the transformer Pri.)
Output 56.6 Volt DC 20 Amps with Current and voltage control.
Fahim Baig
fahimbaig2@gmail.com
Thank you Goldsmith brother for a quick reply, I was not expecting that people read posts daily... :)
you are right about the sizing, but over the years I have found out that Designs are not based on 100% calculations, the calculations serve only for a guide line.
first thing you look around is...
AOA
Dear Goldsmith
I have seen the pages and then the discussion about wire size....
do you think it would be better to use Litz wire instead of thick wires as for high frequencies they seem to be more efficient.
btw I dont get Litz wire here in the market so i have developed a small gadget to...
Re: Thinget PLC
hi,
can anyone suggest how to use the High Speed Counters on an XC5-32
I want to use X0 as input and X3 as Direction of counting
how to do that?
thank you
Hi
can anyone help me in making an addressing software to Read and write 12byte long records and then reading them and sending them to the USART.
thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
