Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thank you vfone. I know that it is possible to design it myself (and I am capable of doing it), but I was questioning whether there are already such components on the market.
Thank you for your anwers.
Meanwhile: the first component is required to be a coupler. Signal drop of -20 dB is accepted. So I design my RF chain to have a -20 dB coupler and afterwards a power splitter.
Hi :)
Does anyone know a single device that fulfills the following functionality? Unidirectional signal from top to bottom: At first two signals need to be coupled together. The result is then splitted into two branches.
Hi.
Assume I take a general textbook, say Balanis' "Antenna Theory -- Analysis and Design". Further assume I use the exact structure of the book, all derivatives and all thoughts and ideas. Assume I create an own course with all that material (I use only redrawn pictures) and I make clear that...
Hi,
I'm sure I'm not the first who ever asked about the problem of plotting a 3D farfield exported from CST MWS. However, since days I try to get a reasonable solution with mesh(), surf() and plot3() in Matlab. All of this does not work. I found a function that does the job: patternCustom()...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.