Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The rated current for the bms is 15 amps while during discharge i am anticipating 100 amps since the hybrid inverter will cut of battery at a preset lower voltage, I want only the balance function of the bms during charging and want to skip the bms during discharge. Do you think this...
Please help me how to wire the circuit with MOSFET (100 amp mosfet as per requirement of load) so that charging of the battery is done through the BMS but discharging is direct by bypassing the BMS since it is rated for 15 amps. Please see the attached image...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
