Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: usb mobile phone charger
Well this would not work I don't think !!
Mobile phones contain their own charging circuit don't they
So all that is needed is the correct voltage supply the phone will do the rest
Re: usb mobile phone charger
Very simply you could just use a Zener diode resistor arrangement.
You can sink upto 500mA from USB port.
So get a zener for the voltage needed to charge the phone.
Set up as follows VCC--Resistor---Zener---Ground.
May work
Only took 2seconds to dream up :angel:
RTKernel
Anybody got a user manual for this ???
I am stuggling with the 16bit DOS version of this software and I would be grateful if there was anyone who could help
Cheers
Ian
Re: ST10 PowerUp Problem
Are you sure the reset pin is being held low for a small time (200ms) after the st10 has powered up !! If not then the micro may behave erratically
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.