Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Consider the AVR microcontroller high total current level limits through its outputs, 40mA max per pin, 200mA max overall.
Which is the current you intend to supply to the LEDs? Perhaps a Power LED Driver plus your transistors could be an easier solution for your design.
If you are new to FEM analysis, i should suggest you to stick to the tetrahedral meshes, and investigate different methods for mesh refination, putting your attention at increasing the resolution of the mesh at the critical points of your design. Most meshing algorithms are made for tetrahedral...
Though originally it is defined as acceleration (m/s2) or as velocity (m/s), It is fine to use the concept for other variables, such as the angle, as you indicated.
Hello people,
Can somebody confirm me if LabCenter Proteus software can simulate the EEPROM registers for the Arduino Atmel megaAVR ATmega328P, for the standard instructions EEPROM.put and EEPROM.get or similar in the eeprom.h library?
Thanks in advance.
Re: What type of power supply should i use for the proteus file?
Try the Generator Mode>Sine Generator, putting attention in the Delay>Phase parameter, which should be 0, 120 and 240 respectively.
For the Voltmeters, try the Probe Mode>Voltage, which will give you the proper voltage values in...
The following Proteus model gets the IC-VCE curves for a FMMT415 Avalanche Transistor Model, from a Spice Model found at www.diodes.com.
It works fine as is, but fails when changing the second analysis from the first source into the second one.
Can somebody check what is happening in here?
I...
This 1993 Spice 3f3 Manual in pdf, which i think it is roughly the same than this unofficial online document for the **broken link removed** in html.
The 1993 Spice 3f5 is the current Spice version, and should be the reference for the ProSpice implementation inside Proteus according this...
I have a serious problem with Labcenter Electronics, Proteus Professional 8.
What i need is to simulate nonlinear analog current sources with several variables, mainly, a function I(V1,...,Vn,I1,...In). Some matematical functions and if-else conditions.
Nothing so complex but enough for making...
For the EasyHDL language, for Labcenter Electronics Proteus 8.
I have the exact same question than this closed unanswered post.
https://www.edaboard.com/showthread.php?289111-Help-with-Proteus-EASYHDL-analog-input
For the only help available on internet, and in the included help...
Dear all,
In Proteus, it is possible to obtain the current through a component, like in Spice, this is, with a functional call
R1[i], D1[id], I(R1), or something like that, for i.e. a Transiente Analysis?
Thanks in advance,
No, hehe, i am not talking about anything sophisticated, just navigating inside a schematic.
I already configured several Keyboard Mappings, but i am asking if the panning through the middle button works that way, or is just my case for some weird reason. I could remember this behavior is also...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.