Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have an issue with the +5 V output on the following PSU.
Thermaltake Toughpower 750 AP
Model: PSH-750V
REV: B
P/N: W0116
Testing the PSU with a tester, the PSU starts normally with all voltages showing!
The +5 V outut shows to 5.1 Volts, but a few seconds later (about 2~3) it changes to 4.1...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
