Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
thanks you.
your method depends on the wegiht. and, can not get the quite arbitrary&multiply output voltages. for example, i want to get a output of 1.61V and 2.05V. in this case, your strategy is disable.
Added after 1 minutes:
many resistors!
hi, the current is below 1ma, and the voltage is below 5v, and i need more outputs than one. for eample, 2V, 3V, 3.3V, and so on.
but i think the value is not important. the key is how to do this.
hi guys,
i have a problem of how to design a resistor network to generate the needed voltage by using as few squares as possible. is there any normal procedure to do this? or depending on the experiences of the designer?
i wish there are some reference books to me. if you have any advice i...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.