Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi guys,
I found this document. In the "Short PCB Stub", they said that "If the trace runs parallel
to ground, the real part of the antenna impedance will be
approximately 10 ohms. In a hand-held unit, the impedance
will be raised substantially through hand effects. For a tenth
wavelength strip...
does matching circuit have huge impact on resonant frequency
I simulated the short antenna (length = lambda / 10) with L component right after the feed point. However, i felt it was too hard to resonate at 433 MHz (I used HFSS to simulate)
Can you explain more insight in the antenna in the picture. Example, if I want to switch to 433Mhz in this circuit while remain the length of trace antenna. How I tuning the L2 value
Can you tell me some documents and formulas to calculate the value of series inductor and matching network.
I am overwhelmed by documents that I search in the internet and I dont know what is exactly
Thanks
Hi guys,
Can anyone tell me what kind of antenna in some key fob.
As i can see, it is just a trace which is 7.5 cm length (the frequency 315 MHz)
I attach the image of keyfob below, can anyone explain to me how it work and some related formula to design with another frequency.
Thanks.
Hello everyone,
I am a newbie at antenna design. I am trying to simulate an electrical pcb small antenna using HFSS, but the S11 plot seem wrong (my expectation is at 433 MHz).
Anyone tells me how to set up in HFSS to simulate small antenna in the right way
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
