Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi keyur
I received an email about your question in Wednesday,and frankly I was very busy.
Forgive me because I check forum Infrequently.
First of all I should tell you I am a reverse engineer.I look at everything from the opposite direction.I learn how to design a multilayer pcb without having...
Hello Jim
I always design my board in PCB document . if my customer need Schematic I draw it separately , that's Because I should deliver PCB in a
specific time . but this time I had a same problem in this project and your solution helps me .
Thank you so much.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.