Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Yes, there are few videos available in youtube through which we can learn.. If needed kindly let me know will give few references too...
- - - Updated - - -
Thanks for the info...
Seems EDx is fine for learning.. But couldn't get enough details on diverse electronics & hobbyist (circuit...
Hi,
As I know some basics of hardware design. Now I Wanted to learn Hardware Circuit Design in depth.
Could you please refer some websites, Pdfs, youtube channels, etc.. to understand in detail & to learn.
The datasheet mentions that module wants TTL levels, not RS232 levels. So you should remove the MAX232 from the circuit and replace it with TTL-CMOS level converters.
Sorry I misunderstood your question and got confused with another post.
Could you please try by providing some delay immediately after enabling the interrupts.. Generally, There must me at least 20ms delay between successive usage of routines
Yes, Understood... But not completely.. What is the interface which you used between your EEPROM & PIC? What is the EEPROM which you are using in the design?
Share the part number.. If possible post your connection diagram.
The problem is not with your English. It is with your explanation. No...
By this statement I have understood that you are switching off your board & not switching on. Kindly explain clearly the methods which you are following for writing the data at the location and also the method you are trying to read back at the same location during power on & Power off
I'm asking this question to prepare a document which could be used as a guidelines before selecting an ADC. That's the reason I want to know that if anything else is missed.
For ADC selections will be following 2 criteria:
1. Primary criteria
2. Secondary criteria
Under Primary --> Accuracy/Resolution, Error, Sampling frequency, ADC types, Input signal considerations, environmental considerations, EOL
Under Secondary --> Number of channels, Interface, Supply...
Hi All,
I'm getting a notification and there were no new posts found in the threads which I have subscribed. But still notification is displaying. Attaching the snap shot for your reference. I want to know for which option the notification is showing
Re: Do i need max232 ic . . ??
Yes, It should because the datasheet of your part says this.
"The module supports one full duplex serial channels UART. the serial connections are at 2.85V LVTTL logic levels"
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
