Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The first, you must determine which architecture is used. Then get the NTF expression according to the architecture. Using the two NTF expression, you can get the coefficient. The book analog integrated circuit design of David Johns gives a good example.
I'm designing a RC integrator with a 1µF Cap connected between opamp's negative input and output. When I design the opamp circuit, how to determine the load of the opamp? Is it 1µF? I don't know.
Thank you for your help.
site:www.edaboard.com ad736
I'm designing a circuit to average a pulse signal, which frequency is from 120 to 600Hz and amplitude is variable. How can I get the exact average value of the amplitude in 100ms?
Thanks.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
