Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
ldv setup.sh
if you use bash .
open the file .bash_profile which in your /home/yourname
and add the line : export lm_license_file=/path/yourlicensefile
ether change
OK, It's easy .
At the top of the file ( /etc/rc.c/init.d/network ),
You can add a new line like this :
ifconfig eth0 hw ether xx:xx:xx:xx:xx:xx
Good Luck !
I think use the WINE . perhaps .
But the best way ,I think ,is use the Linux version .
Like H*D*S,M*o*d*e*l*s*i*m ,s*y*n*p*l*i*f*y.
Fankly said ,I like to work on win*dows platform .
Eeve if I like the Linux .
Xilinx said it works on linux .
But I think that perhaps you must install
it on linux by use the WINE .
On the xilinx web ,some support about it .
The BB's f*p is so hard to connect .
I haven't got the software .
a pity .
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
