Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Actually the power capacitor is connected to the RC-filter rectifier which means there are two capacitors.
Also,if I select ESr as the parameter ,is it possible to do the estimation in Matlab? Thanks!
HI,
I am doing the parameter estimation of the power capacitor.
I have used this topology to measure the voltage and current of the cap.
https://en.wikipedia.org/wiki/Rectifier#Rectifier_output_smoothing
What should I do to estimate parameters for the capacitor ?
And what are the parameters for...
Sorry for giving too little information.
I did plot my data in matlab and it looks same as NI showed
My phase angle is very very small which is about 0.05 degree
However, I have to calculate the phase angle by using an algorithm
Hi all
I just got the graphs of current and voltage from the NI device.
I want to measure the phase difference between them.
And, I have a program to measure the phase difference, but I don't know how to import my graphs into the program.
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
