Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
I'm trying to connect mcp2515 to LinkIt ONE board(compatibile with Arduino). I'm using LinkIt ONE(digital pins operates at 3.3v) + Level translator(TXB0108PWR) + CAN module with MCP2515 and TJA1050 on board. I cannot fully determinate whether my initializations goes wrong or good. Each...
Hello everyone,
I have problem with receiving frames from my CAN. I am using SJA1000T controller + TJA1050 interface. CAN communication module is connected to my Raspberry Pi. Below there's my connection scheme.
I've already worked with other devices on serial port and it worked fine. But here...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
