Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
recently I did a simulation in CST where I just needed to review efield results in 2D plane cross section (e-field monitors).
I realized that when adjusting the accuracy setting from initially -40db to -30db or even -20db, I see almost no difference at all in the simulation results but...
Hi stenzer,
thank you very much for your reply.
Meanwhile I was able to check it:
By using the post-processing template and evaluating the electric field at arbitrary cooridinates with settings:
Component: absolute | Complex: magnitude I get this result:
Fieldvalue: 5.807928 V/m
The E-Field...
Hello,
after simulation I can export the electric field values in CST Microwave Studio Suite.
The e-field is exported in complex form, to be specific in the folowing form:
x | y | z | ExRe | ExIm | EyRe | EyIm | EzRe | EzIm
As you can see, for every spatial point in 3D volume (x,y,z) the...
Hello everyone,
I'm about to learn about UHF-RFID and found this whitepaper: https://pdfs.semanticscholar.org/3c79/79630d8fb7c18674cdb5e32c72413eb3133b.pdf
On page two, the second paragraph is says:
The farfields can be used to identify the best position and orientation for the RFID tags...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
