Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The difference between series and control circuit i’d have to look up, but guessing it means such different range of amps is more difficult.
These are intended for a bicycle parts washer. It’s circulated degreasing fluid, from a reservoir up through a brush fitted tap into a sink. Guessing...
I see, saying back of plug could be confusing.
This sounds simple enough now. Thanks.
There is another washing machine component i’d like to wire up as part of this same thing i’m making...
Yes, it does just have 2 wires, and yes Brian it does seem to mechanically work like you say and use the gravity.
Earthing sounds a good idea.
In terms of a circuit:
-i’d like to add a switch of course. -Should I fuse it?
-And can I wire it straight from the plug, or should I use the original...
Hi all...first post here. Can any electronics genius give a total amateur some advice on wiring up an old washing machine pump? It pumped out the waste water. I think I could work from a circuit diagram if I could find one.
I have got it to run since pulling it out of the old washing machine...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.