Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi!
I have one problem with Proteus package for part LTC1864 ADC. I try to change the package from DIL08 to TSSOP8 but the package gives me error (red circles) as shown in the attached figure from the PCB layout. Can anyone pointed out what is the problem?
Thank you.
Thank you for your reply.
I actually concern more about type of sensor that gives consistence measurement on water...I mean it is not easily affected by water surface such as not easily absorbed/reflected by the water...
Hi guys..
I have one simple question. What is the best sensor can be used for range measurement on water surface specifically for obstacle avoidance?
Thank you.
Hi KlausST!
Thank you for your reply. Actually, i would like to design and simulate (before implementation) a signal conditioning circuit for a ping signal with freq of 28 kHz. Consider this ping is produced by an underwater pinger. Now I have to retrieved this signal through a sensor (a...
Hi guys!
I have one simple question. If I design a filter circuit for a sine wave signal, is it possible for the same filter circuit to be implemented for different type of signals (for example square wave, ping, etc)? The signal have the same frequency and used in the same environment. If yes...
Thank you barry. I will study on this. For now, this is what i have from the IMU:
X: -0.16 Y: -0.59 Z: 8.67 m/s^2
X: -0.20 Y: -0.55 Z: 8.63 m/s^2
X: -0.12 Y: -0.59 Z: 8.63 m/s^2
X: -0.16 Y: -0.55 Z: 8.63 m/s^2
X: -0.16 Y: -0.55 Z: 8.63 m/s^2
X: -0.16 Y: -0.59 Z: 8.63...
Thank you barry for your response. I do have accelerometer (I have 10 DOF IMU from DF robot). But the problem is does it really represents acceleration due to motion? Or acceleration due to motion + gravity acceleration?
Hi!
We know that accelerometer measure acceleration due to motion and gravity? The question is how we can obtain acceleration measurement due to motion alone?
Hu guys!
Anyone could help me solve the following problem. I try to simulate time delay estimation in Simulink based on GCC-PHAT method (see Fig1 for explanation). My FFT is correct as I checked it but I'm not sure why I can't get the correct sample delay (in this case 15). My Simulink model is...
Thank you for your time. Ok let me make everything clearer. I bought low cost hydrophones (electret based) as in datasheet (as in the link below) for about USD159 . The manufacturer told me, that the hydrophone works with common electret microphone amplifier. My purpose is to use four...
After long period...now I have time to continue my project. Actually my intention is to localize underwater sound source (which is a pinger) using hydrophone array i.e. at least four for 3D source position (x,y,z). It is assume that the source distance is around 50m from the array. How to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.